Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As of yesterday all of my tenants have a really poor health score. I know what I did that caused it. However, I don't know how to fix it and was hoping somebody could point me in the right direction. I have a basic lab setup with 2 spines, 2 leafs...
I am running APIC version 1.2(1i) and am trying to setup/create an L4-L7 device - a virtual F5 running 11.5.1. I have the latest F5 device package (version 1.2) installed as well. I've walked through all the steps a bunch of times but I keep gettin...
Hello,
In our environment we have a border firewall (checkpoint) that everything goes through before it even hits the ACI fabric. The default route in each VRF in the fabric goes out to the border firewall. So far I am able to setup some contracts...
Thanks for the info Orf. And you are correct, even though it doesn't pass validation it can still be executed.I ran into another situation. On the "NetworkDevices" input if I select only 1 device, and then select that same device for the "LoopVarNet...
Hi Orf,I'm trying to use this in our UCSD 5.5 environment, but running into an issue. It imports the flows and tasks fine, but the workflow for "add fabricpath vlans" keeps failing validation. It says that the "on success" link in the email task ca...
Hello Tomas,
Thank you, using your advice I was able to login via Postman and post the changes with the status="deleted" and all of the gui created "__ui_" objects I could find have been deleted now.
However, the health scores are still low and the...
I know I have been in the Basic Mode GUI before, but I have never configured anything from there. If you look at the attached screen shot, this is right where I was when I configured the VPC before. Notice the "advanced mode" in the upper right cor...
