Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,This might be a stupid question, but I am wondering why my Aironet 1602i and 2602i access points connected to the same controller would use different channels for the same network. Would this be to avoid interference? If so, I am planning to put 9...
Hi,I want to make sure that 3-4 computers connect to each access point in the office to minimize bandwidth usage. How can I do that?In other words, I want some computers to choose an access point over another. Is there a MAC address filter or somethi...
Hi,I use a WLC CT 2504 in the office and I have two problems regarding device discovery within the network. I would appreciate if you could help me with these problems.1. I want to see the network devices in the Network panel in Win 7. I can ping all...
Hi,I have a CT 2504 controller and I have connected 1602 access points to it. They created a 300mbps wireless network that works well. I am planning to enlarge the network by adding 5 2602 access points. The users that will be connect to the 2602 aps...
Hi,I am using an 1602i access point for my company's wlan. The adapter that I use for the computers is Cisco Linksys AE3000 (which supports up to 450 Mbps). However, the wireless speed does not exceed 144 Mbps even though the computers are very close...
I am using a controller. So what you are essentially saying is to group the APs and assign WLANs to each group. Right?If I want to separate the networks, too I can assign those WLANs to different VLANs.Is there are a different way, perhaps a MAC addr...
Well the computers that are connected to the office network (192.168.0.x) get their DNS servers automatically. Their primary DNS server is 192.168.0.7 (the IP address of the office server) and the other two are the ISP's DNS addresses. I tried inputt...
