Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I need some help configuring my cisco asa 5505.I've set up a VPN tunnel between two ASA 5505Site 1:Subnet 192.168.77.0Site 2:Have multiple vlans and now the tunnel goes to vlan400 - 192.168.1.0What I need help with:From site 1 i need to be able t...
Hi.Can some one tell me if I did the NAT part right? Both dynamic and static.To be able to reach one vlan from another I created a Nat between them, is this the right way to do it? I can still limit the access between the vlans based on the access li...
Hi.Thanks for the tip.would the servers that have static nat be affected if i "close" down the outside interface.If so should I then just create an any-any rule based on the service.example:RDP (3389) need to be open for several servers. should i the...
Ok.Some one here told me to use crossed network cables instead of straight. But then nothing should work if that was the problem?But when i configured the asa. I put all my ACL on in, and could not connect. Then I moved them over to outgoing and it w...
