Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I recently had some trouble with my ASA 5505 in that the running config would not be saved after a reboot. Definately looked like a hardware problem with the flash memory. I have since bought a new flash memory card and copied the contents of ...
Hi all,This may be a simple question, when I make changes to the config of my ASA 5505 and write mem (or use the ASDM to save running config to flash) the changes are not being saved.Is this going to be a problem with the Flash Memory on the device?I...
HI,I am new to the Cisco world, so any support/patience would be appreciated. I have been having a hell of a time trying to get internet to the inside laptop through this ASA.I have basically started fresh, from a clean image. We bought these with th...
just to confirm, i successfully setup our ASA 5505 thanks to this page. The following works:interface Vlan2nameif outsidesecurity-level 0pppoe client vpdn group BTINFINITYip address pppoe setroute!vpdn group BTINFINITY request dialout ppoevpdn group ...
Can anyone help with this? I have tried a new CF card and am getting the same problem. I have tried to erase disk0: -- Disk0: is not presentSo i have 3 cards now (1 of which is the Cisco CF that came with the device, and they are all acting exactly t...
The only other thing I would like to say is that if it is a problem with the Flash not being detected, how come the old card now is producing exactly the same results as the new card?I put the old Cisco flash in and it does not boot into the image.St...
