Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,This is the first time I ask in the Cisco Support Forum. First of all thanks to everybody for making this happen.We need to install AppResponse Expert from Riverbed for application performance monitoring & troubleshooting purposes.This tool ...
Hi again,Our config is as follows:monitor session 1 description Riverbed AppResponse POC source vlan 1510,1600-1620 rx destination interface Vethernet367 no shutand we receive traffic from all VLANsI don't think you need to create another monitor...
Hi Andy,Finally we didn't need to assign any port to VLAN 4095.We got what we needed just by configuring SPAN (monitor session 1) in our Nexus 1000V (see config in previous answer)Vethernet367 corresponds to the VM we wanted to send all the traffic t...
Dear all,We finally got what we wanted configuring SPAN in the Nexus 1000V.Using promiscuous mode in PVLANs sounds confusing and was not what we wanted.Thanks anywayAlfonso
