Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This may be a change in IOS XE vs the old IOS.
Previously had 3945 routers setup with a Policy Map, using an Access-list to match services for QoS. I could do a 'show access-lists' and it would show the number of hits on the ACL where QoS was appli...
I have a fairly large site with 150+ remote locations. We are adding redundancy at our data center, replacing one router running BGP, DMVPN and all connections (Internet, EWAN and MPLS) with 3 routers. The idea is to use the existing router just fo...
I have an ASA5512 feeding two Catalyst 3560's connected via 10Ge Fiber. Also on the network is a wireless controller for 7 access points. This is a high density environment.I think I want to setup a couple of logical networks: a 192.168.1.x for th...
Fairly new with ASA's, and could use a little help. I have an ASA5515 configured as a DHCP server in a customer environment. Clients that obtain their IP's via DHCP lose network connectivity after a short period of time, however clients that are st...
Good find. Thought that would do it once I read the article...
I issued the commands, then removed the service-policy statement from the interface, re-added it to the interface and did a 'show access-list' and nothing...
I have another access-gro...
There's another router doing nothing but DMVPN that plugs into the switch as well. Under the routers at the data center is our virtual environment; all the servers, hosts, etc.
Out lots are connected via the MPLS and all come back to the data cente...
Attached is a very basic layout. The two routers circled in red are the ones I want to setup HSRP (or a redundancy solution) on.
The EWAN connection is between the colo and our corporate office directly. If MPLS our corporate office can still get ...
