Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have a quick query regarding splitting our subnet down.
Basically we are a managed school and receive an IP range of 10.193.8.x/21 with a Cisco router located on site with an interface ip of 10.193.8.1 and can only get out to the internet...
Hi all,I posted a while ago that we were having problems translating an IP for a printer (located here https://supportforums.cisco.com/message/4099013#4099013)We still haven't been able to get it working and thought about another approach which is to...
Hey all,We are currently having an ASA setup as a NAT to translate outside IPs to our internal LAN IPs which is all working fine.However our city council has a printer which sends a job through to an IP address which can no longer be accessed due to ...
Apologies for the late reply.So you reckon that any software installed on our PCs should be able to access any ports? I know we are behind another firewall but we put the request in and apparently they have opened those following ports but we still c...
Yeah its really frustrating that we can't solve it.Regarding the ports, we have a piece of software that apparently needs to communicate on 52221, 52222 and HTTPS (443) but it still doesn't seem to communicate. Apparently that IP in the config is the...
Still not working! I've just tried translating another 10.100 IP address to one of our web servers and it works fine!I think we've decided just to stick another switch in and have the printer outside of the firewall as its starting to make us go insa...
Still no luck after that.In theory if the translation was working shouldn't a ping sent to 10.100.104.20 be picked up by 172.29.8.20? Because at the moment i get no response.Many thanks
