I was working with Cisco case management. I reset completely the router, then cleaned browsers. After advise to also unplug Ethernet wire after changing IP - it seems to work now. I will be doing more testing in the next few days and will post if iss...

Just got response from Cisco - they closed my ticket not resolving the issue. Be prepared to deal with the bug for at least next few months. Good luck.

The bug in the newer firmware still exists as of the firmware 1.0.01.18. You cannot change IP address on the LAN or even create VLAN2 in the firmware 1.0.01.18 After downgrading to the 1.0.00.33 it works. IF you create VLAN2 in the older firmware AND...

this is not the case of "small business routers", there is many "small business" routers which will allow you to customize subnet and they are way less powerful than RV320 - in my opinion it is shortcoming off the software design. Here is a proof:RV2...