Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been having consistent problems with my ISDN line from Verizon. It is a standard BRI. I am over 18000 ft from the CO, so they installed a repeater outside my house. The ISDN line will come up but I get alot of debug messages and the line goes ...
I am having consistent problems with my BRI. I have an exremely simple config and the line keeps dropping. I have had verizon out about 10 times and they can never fix the problem. The line seems to drop the most during the day. I actually logged the...
I have been having trouble with my ISDN BRI line ever since it was installed. It seems that the layer 1 keeps deactivating and I am getting strange debug messages. Can any one determine what is happening on the line based on my attached log? Verizon ...
Hello all I am having trouble with my ISDN BRI. The line drops from time to time and the performance is very slow at times.(38K with both channels dialed in. I know the router is configured correctly as I am familiar with the IOS and the same router...
I have been having trouble transfering large files on my network. When one of my clients uses SQL enterprise mamanger to connect to a group of 5 SQL servers in the DMZ it causes all large file transfers to and from the Internal int to the DMZ int to ...
I have cleaned up the config, removing ppp multilink, chap and compress commands. I am not able to add the isdn service b_channel 2 state 0 command to my config. Still getting the same problem. As a side note after making the changes last night, I fo...
I verified with my ISP that multilink is supported. I think its a telco issue due to the following debug output.I am especially concerned about the messages "ISDN BR0: L1 ERR IF_ACTIVE" and"ISDN BR0: Recvd MPH_EI2_IND from L1" which occurs right befo...
I am running 12.2 I think. I can post the config. I had no problems with this config and IOS at my other home a few months ago. Same U interface, cable, etc..The output was from debug q921. Anyone know where I can find and explanation of the debug me...
No just via windows explorer copy and paste. And again when the SQL Enterprise manager disconnects it works, and it is working fine now since I did a static NAT for the client using the sql ent mngr.
The client was configured to use both. But SQL enterprise manager works fine. It was just that when anyone used SQL Enterprise Manager to connect to the group of servers inthe DMZ (4 servers) large (>10MB) file transers failed between the Int and the...
