Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have an ASA 5510Cisco Adaptive Security Appliance Software Version 8.2(1)Device Manager Version 7.1(1)52Compiled on Tue 05-May-09 22:45 by buildersSystem image file is "disk0:/asa821-k8.bin"Config file at boot was "startup-config"Hardware: ...
I know this is an old case but I just wanted to add to it in that I just had Cisco scratching there heads for 2 weeks about an issue where we had an AP (nothing special, same as our other 100 AP's) would not allow clients to connect to it.As soon as ...
hi Jcarvaja,There is nothing from a firewall perspective, we have the carriers CPE router and from there it dissapears into the ether. Should I check with the carrier to see if they are filterting these? (they were not in the past AFAIK)Cheers,Aaron
tracert -d 8.8.8.8Tracing route to 8.8.8.8 over a maximum of 30 hops 1 1 ms 2 ms 1 ms 192.168.1.1 2 * * * Request timed out. 3 * * * Request timed out. 4 * * * Reques...
hi Jouni,I have tried it on multiple PC's yes. the traffic all goes through our core switch first but that is not setup for firewalling, just switching. If I set my PC's default gateway to the ASA even, i get the same blocked traffic, just *'s unti...
hi, Thanks for offering to assist, below are the results you requested (i have obfuscated our external IP)ASA01# packet-tracer input inside icmp 192.168.0.215 8 0 8.8.8.8 Phase: 1Type: ACCESS-LISTSubtype:Result: ALLOWConfig:Implicit RuleAd...