Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So, never seen this before, it's the 'reverse' of most issues, where people normally can access internal systems but not the web.
Here I have a AnyConnect (4.2.x) client connecting to an 5520 ASA on 9.1(6). When connected the remote users can acce...
Here's the story...I have a ASA5505 sitting at home on the end of my ADSL/2 connection, working happily away for the last few years.Then along comes this upgrade from ADSL/2 to vDSL, so my ISP connection speed jumps from 8.5Mbps down to 72Mbps down a...
Hi all,I've been working on my ASA5505 quite happly with the old version of 8.2... for my 642-618 exam, but then it came to having a look at the 'upgrade' and I'm now running 9.1(3).....Since it's 'only' at home I took the time to rearrange the home ...
Opps, err forgot to add the plan was full tunnel and use a proxy server while connected to give users web access.
This actually works, so users can access MSN, Google etc. as long as it's only HTTP or HTTPS traffic it's all working...
Hi, sorry was on holiday......
Anyhow here's the NAT, We have two ISPs CSS (outside) and Virgin (Virgin):
nat (inside,Virgin-line) source static local-nw local-nw destination static vpn-nw vpn-nw no-proxy-arp route-lookupnat (inside,outside) source ...
Had a look as the Spec sheet...Now this is the bit I'm concerned about is the fact I have used the basic IPS functions. However, in the spec sheet it state in relation to the IPS "Up to 75 Mbps with AIP‑SSC-5", I am assuming this is used for off lo...
Not done this through the 'wizard', but having done this through the command line it does work on a 5505 running 9.1(3) - I use port 8086. Relevant lines for sshwebvpn no enable outside port 8086 enable outside anyconnect enable tunnel-grou...
Hi,Got the same problem here with 9.1(3) and using AnyConnect 3.0.5080, DTLS and RSA_AES_128_SHA1 cipherI tried setting the compression on globally with(config)# compression svcBut when connected client still shows Compression as none.Thanks
