Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, can someone help me with such thing: need to configure c170 as mail gateway for postfix. the thing is, i've done all the initial setup, set RAT to accept all emails for my domain and for other domains, as i use one interface deployment solutio...
Hello once again. I used your advices and configured as it was in the manual. But, i had an issue with authentification, as i do not use active directory. and occaisionally i found an article about smtp forwarded authentification. and i manged. Now e...
1 The RELAYLIST Sender Group in Host Access Table has 1 server listed (postfix one, which ip ends on 146).2 In SMTP Routes I've got to set only ip for my Domain? even of i use one interface deployment?3 In RAT, i also must use Accept only for my doma...
The situation is the following: i've got two c170. they have two ip's. Both these ip's are chained for one smtp record whith different metric for "clustering." And one pop3 record for my dovecot server which is installed alongside my postfix server. ...
Yes. It is in SMTP Routes for All Otehr Domains. But when i remove it from there, all the outgoing messages go to their destinations, but they are sent by ESA. And they are listed in Incoming mail in the overview. Is this ok in One interface deployme...
HERE IS WHAT MY ESA SAYS:Received Time: 17 Dec 2013 09:28:42 (GMT +02:00)MID: 74842, 74841Message Size: 856 (Bytes)Subject: 123Envelope Sender: test@xxxx.xxx.xxEnvelope Recipients: xxxxxxxxx...
