Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i have a strange problem which i am trying to resolve, but i have run out of ideas.I have a router on which i have Anyconnect as RA , and DMVPN to form S2S vpn with other locations.I can successfully connect to router via anyconnect, it will pu...
Hi cisco community,i am now trying to achieve a scenario, which is in pictured below.It should be a site-to-site VPN on IPSec. The site on the left is behind PAT and for our purpose will be marked as Branch site. I do not have access to the ISP route...
Using different subnet for Anyconnect hosts and configuring the virtual-template with ip address from this range fixed the problem. I am still curious though, why it was not working with the subnet same as the local lan. Will have to try some more te...
Hmmm, i have added access-list 105 deny ip 192.168.5.0 0.0.0.255 192.168.5.0 0.0.0.255just to be sure but it does not fix the issue.Which is expected from my side as the anyconnect vpn pool is " ip local pool SSLVPN-POOL 192.168.5.200 192.168.5.210...
I am not aware of any specific command to show some more complex bandwidth utilization stats or something. You can also change the input rate interval if that will help you.Maybe you can try to poll your device using snmp and get traffic stats with i...
Hi, i think your problem is this service policy on site A router:policy-map type inspect permit-server-traffic class class-default dropThis service policy is controlling the traffic coming from out-zone (outside of your local lan) to in-zone (your l...
I am not familiar with this hardware but general steps you can take:Disable AP-isolation (ap isolation makes your wifi clients talk only with default gateway and then to internet, local lan is not reachable), probably not an issue as inter-vlan rout...
