Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i All,I am a newbie to Ansible, writing a few codes this week. I found the "no shutdown" command under the interface configuration prompt does not work. Other commands such as "ip address x.x.x.x m.m.m.0" run successfully. The device I used is the cs...
The other difference is 7960 is much slower than 7961 in restarting from CME router.R1(config-telephony)#restart all reset 2 phones 5 seconds, this could take several minutes per phone Starting with 7960 phones
