Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,What are the implications of blocking band 3 between a WGB and Root using the "dfs band 3 block" command. Note, this is enabled by default on IOS AP's as stated below. Does it in anyway affect the use of 802.11n MCS rates?http://www.cisco....
Hi Experts,Let's say that I want to configure a Preauthentication ACL to allow guest users to ping a server or resources on a particular subnet prior to web authentication. If I specify the permit statement for ICMP, should I specify ANY direction or...
Hi Experts,I see that these are the commands for 802.1x, but what is the PSK version of this command?wlan security wpa wpa2 ciphers aes enable 1wlan security wpa akm cckm enable 1Thanks,John
Hi All, I am having a problem getting my MSE joined to my WCS. It was joined at one point, but we changed the IP address on the eth0 interface from one IP to another and now it's showing up in WCS as UNREACHABLE. I have run through the setup of my MS...
Hi All,I think a MAC address might be mistyped in the MG list on one of our 5508 WLC's. - What is the command that will display the controllers proper MAC address so that I can validate. I have tried all of the commands that I know of. Would it be th...
Looking at document:http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/71978-acl-wlc.pdfIt says:These are some of the rules you need to understand before you configure an ACL on the WLC:If the source and destination are any, th...
That seems to be correct, but I get a strange error when I try to deploy it. wlan create 2 contractor contractorwlan radio 2 802.11bgwlan interface 2 int143 wlan security wpa wpa2 ciphers aes enable 2wlan security wpa akm psk set-key ascii...
