Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all, i have a customer (small business) without a static external IP adress. They use a VoIP solution with an internal appliance and i have to forward some ports and a port range to the VoIP device. Using a public server did not work as it need...
Hey all,
i have a customer with an ASA 5505 and we use anyconnect for VPN connections. Everything works fine except for a reconnect at around 65 to 67 seconds after the initial connection.
I found this https://www.cisco.com/c/en/us/support/docs/...
Hi all,I need some help with setting up QoS for VoIP between two Cisco ASA 5505 with Site-to-Site VPN.There is no need for bandwith reservation, only DSCP 46 (EF) should be highest and DSCP 26 second highest queue and the rules should only apply to a...
Hi all, i have a brand new ASA 5505 which wont let me access with either https or asdm. I tried from 2 different computers, with manual IP settings and DHCP from the ASA. I can ping the ASA and connect via terminal but not with https and asdm. ssh do...
Hi all,I`m facing a strange issue with a customer. I`m using a Site-to-Site VPN between two ASA 5505 to connect his network to ours to replikate between a NAS on his side and a NAS on our side. I use the same setup with other customers and it`s worki...
Hi, this does not work object network VOIP_SERVERhost 192.168.100.10nat (inside,outside) static interface service RTP-Daten RTP-Datennat (inside,outside) static interface service Autoprov Autoprov Leads to the config only having the last service pres...
Since i am out of office until monday: Would this be the correct solution? And with or without the VOIP_Server given in the nat rule? Thanks in advance!
OK so this below should do the trick? From what i saw online the VOIP_SERVER should be in the NAT Rule like i marked in red below? object network VOIP_SERVERhost 192.168.100.10 object service RTP-Datenservice udp source range 10000 20000object servic...
Its a Firepower 1010 with ASA Version 9.14(1) Is there no need to open the firewall? access-list inbound extended permit tcp any host 192.168.100.10 range 10000 20000access-list inbound extended permit tcp any host 192.168.100.10 eq 50080
