Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have managed to configure to configure a 857W - it connects to the internet and everything is good - except that I can't ping the ethernet group or make any connection from either the WAN - > inside or Inside -> WAN.I think I have mis-config...
Yay! Thank you SOOO much John.When debugging the authentication I found that the ISP was only looking at CHAP. My config had only PAP authentication set.When I added ppp chap hostname blahppp chap password 7 blahIt all worked like a dream.Thanks fo...
Ok so logically if I'm not getting an IP then I must not be authenticating correctly?just for fun I have added:ppp authentication pap chap callinCurrently investigating the output of: debug ppp negotiationAlso tweeked a few other things - I...
oops - mindless drone copy/paste there.Renamed SSID and removed the wrong one, I'm not fussed with the radio at the moment. could you remove your ACL first on dialer0?I did a 'no ip access-group 101 in' assuming that's what you meant?****************...
More information for people:router#sh int bvi 1BVI1 is up, line protocol is up Hardware is BVI, address is 001a.e321.7b78 (bia 0019.30f5.7100) Internet address is 192.168.10.251/24 MTU 1500 bytes, BW 54000 Kbit, DLY 5000 usec, reliability 255/...
Thanks John,Thanks for your reply I saw the gateway problem earlier but it didn't help much- here is my current config. Still can't seem to connect to things. version 12.4no service padservice tcp-keepalives-inservice tcp-keepalives-outservice time...
