Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone help me out with this strange case. I have very simple scenario with one hub router 2621XM and a couple of spokes 2610 XM and 1600. They are connected over p-t-p serial interfaces over frame relay. Let's take one p-t-p interface as example...
Does anyone knows what following syslog message means?no route to IP1 from IP2where IP1 is PIX PAT address and IP2 is remote server addressAnyone had this log?
I'm seeing some strange behavior on PIX when PAT is enabled and I have to use service resetinbound in order to speed up ident process.global (outside) 1 209.83.175.141-209.83.175.142global (outside) 1 209.83.175.143nat (inside) 1 0.0.0.0 0.0.0.0 0 0F...
Yes, this problem is consistent across all 5 spokes -ping from the hub will add 30-40 ms to the result from spokes creating strange case of asymmetric round trip delay over frame relay network (not quite possible, right?). My first intention was to g...
dest_address is address PIX knows well. It uses it for PAT on outside interface so routing table should not have anything to do with this. any other ideas?thanks
Scott,I can't open TAC case since I don't have smart maintenance. I bought new PIX trough reseller couple days ago and unfortunately ended up with 6.1. I don't know if I can go to cisco with this before figuring out if is config or PIX OS problem.Any...
