Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to configura the above router with 1483 bridging. The pc is using a software to connect. How can I configure the router. I have used before the pppoE and worked fine. Using 1483 bridging with dynamic ip how can I do that?thanx
We have upgraded our ios an all 2610 routers to version 12.2(17a). Since then we faced the following problem: Dialer0 does not triger a call to the main router. To solve the problem, we shutdown the dialer0 interface, save configuration, reload the r...
I used access lists with time range and everything works fine. When I reload the router I found out that nothing works because the time and date are reset to the factory ones(some date in 1993). How can I make the time and date to be saved.thanks
We have upgraded our ios an all 2610 routers to version 12.2(17a). Since then we faced the following problem:Dialer0 does not triger a call to the main router. To solve the problem, we shutdown the dialer0 interface, save configuration, reload the ro...
I would like somebody to explain me why I can assign an ip address to every fastethernet port of the layer 2 switch?What I know is that I can assign an ip address to vlans and not to the port directly.thanks
Thank you for your reply. i would also like to say that my wan interface is ethernet. What will be the difference with the configuration you have supplied.thanks
You may create a subinterface for each vlan. Within the ethernet subinterface apply an ip address and issue the command encapsulation dot1q (or isl) vlan#.i.e. ecnapsulation dot1q 2Use dot1q or isl if your switch supports it.try the following URL:ht...
The problem has nothing to do with the configuration. The same configuration worked fine with the previous ios. With the ios upgrade, the dialer is not triggered to place a call(interesting traffic is met, but dialer does not place a call)
Please find below the configuration. Before the upgrade of the ios we had no problem.thanksinterface Serial0/0 no ip address encapsulation frame-relay no ip mroute-cache frame-relay traffic-shaping frame-relay lmi-type q933a!interface Serial0/0.1 poi...
