Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
QoS in ACI: Intro, Configuration, and Verification
Purpose of this document
The purpose of this document is to explain the foundations of QoS within ACI and how to configure and verify configuration within ACI. This document will not explain QoS fu...
Cisco ACI CLI Commands "Cheat Sheet"
Introduction
The goal of this document is to provide a concise list of useful commands to be used in the ACI environment. For in-depth information regarding these commands and their uses, please refer to the ACI...
Unlikely, but anything is possible.
I see that you have another thread on this issue and that is much further along than this thread. Your best bet for this issue would be to open a TAC case so the TAC engineer can see exactly what is going on before...
Can you confirm that image is in the bootflash of the switch and that it is not corrupted? The md5 hash of the file should be 76ee482c8f9c082c621380289264c6d7
Hello,
Are you following a specific guide on converting back to standalone NX-OS from ACI mode? For example, https://supportforums.cisco.com/document/12268066/nexus-9000-standalone-nxos-aci-conversion-and-back
Are you receiving any error messages fr...
Subash, No problem at all. From that excerpt, it sounds like that linecard will be ACI leaf ready when 9508 as leaf is supported. Last I heard, this was not on a roadmap yet.Thanks,Ryan
Hello, If I understand correctly, it looks like you are trying to setup the 9508 as a leaf switch in ACI mode. This is currently not supported.Also, the N9K-9564TX is not on the list of supported hardware in the 9508 Release Notes for ACI (http://www...
