Hi everyone,I've configured an 1841 running ipbasek9-mz.124-24.T with a hwic1-adsl in slot 0.I'm able to dial up the ADSL2+ circuit and get an IP address from the service provider (BT). I've verified that the username and password is correct and that...
Hi Peter,I've now tried all the firmware versions and the best result I got was with the 4.0.223 firmware: BT-D2#sh ip int brInterface IP-Address OK? Method Status ProtocolFastEthernet0/0 192.168.10.150...
Hi Peter, I do apologise for the delay in my reply.It would seem to me that the line is of poor quality, here is the result of my working 887 on the same line:R1#show controllers vdsl 0Controller VDSL 0 is UPDaemon Status: Up ...
Hi Peter,Thank you for your reply, I just wanted to write in and say that I'm working though your suggestions and will post back a proper response shortly.I didn't want to leave it too long before replying hence this message.Best regardsStuart
Hi Peter,Ok so my ISP definitely uses AAL5MUX, this is the encapsulation used on my working 887 using PPPoA.I've read that both PPPoA and PPPoE are supported and I tried configuring as per the commands you very kindly listed. The result was the same ...
Hi Peter,Firstly may I thank you for your reply to my post, I appreciate your input.I must admit that I did not specifically decide to configure the connection for PPPoA over PPPoE, however I can confirm that PPPoA does work on the line - I've tested...
