Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We moved to a new public CA and I am trying to add a new certificate but everytime I issue the commands, ip http secure-trustpoint TRUSTPOINT-2025no ip http secure-serverip http secure-serverI can no longer get into the webpage, I have to put t...
Hello, We just installed a new 9800-CL controller and updated to prime 3.9 for support of it. Pime says AP Discovery is complete and Telemetry Status is a success but it has not found any of our AP's yet. We have 2702's and we have C9115AXI access ...
Hello, We have an ASA 5515, when our uses use the VPN they can access the local file servers just fine. But when they browse the internet they use their home internet, from what I understand this is split tunneling. Unfortunately, we have a website...
Yes, GUI with openssl. Root, Intermediate, Device cert. For me at least, that what I needed. I don't know if my controller is dumb or if it's just me, but I could not get two intermediates to work. Once I got just one from my CA, it worked.
With one intermediate certificate yes, but with two, this is not the case. When I got a new certificate and one intermediate from my CA, it worked. I could never get it to work with two.
I imported the PFX from the GUI, PKI Management -> Add Certificate -> Import PKCS12 Certificate and it created a Trustpoint named after the pfx file and a secondary one pfxfile.pfx-rr1. It also added a Key name under Key Pair Generation with the sam...
So I wasn't able to figure it out, I was however able to get my CA to give me a cert with just one intermediate and that fixed my issue. I will reboot the controller tonight to fully switch everything over. Thanks to everyone that helpped with this...
