Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have some trouble creating a "trunk" on the ASA5506-x-w. On the old 5505 easy switchport trunk etc.. but on the 5506 with sub-interfacec, i have a hard time to get my setup working, (simple setup)and is a bit embarrassed that i have to ask for ...
Hi The OmniQuery.pl -db sfsnort -e "select serial_number,ip,name,model columns from sensor ;" string will show the JAD.... serial number. Do any on you wither have a list of the Tables avilable from within the FMC like "sensor" in the example above,...
Hi Francesco If you think that it is possible to make this setup, then yes it would be helpfulI am in time zone UTC +2 CEST, I have written you a private message. of course if anyone have some suggestions you are more than welcome to continue to writ...
Hi Have noone ever made a "trunk" from a ASA5506 to a switch before and got it to work? thanks for the suggestions but still no luck I did try to switch out the old 2940 to a new 2960-cx switch to see if there where an IOS bug on the switch but the ...
Hi Again Now i have made a small simple setup at work with new equipment similar to mine just to see if this ware a problem with my equipment. Have anyone actually tried this and made this work?Why can i access cross networks but not connect to somet...
From the ASA ping 192.168.1.200Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.1.200, timeout is 2 seconds:?????Success rate is 0 percent (0/5) sh arp outside 192.168.2.1 e0b9.e59a.6946 14 DMZ 192.168.200.5 c03...
