Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm looking at replacing the FP7030 with the FP2110 or higher. I was intrigued with the options to have a firewall and IPS on one box using the FTD Image. After scanning the documents for configuration setup. We will use the FTD firewall mode, but it...
I added in a google link to the ACL 100 here.
https://drive.google.com/file/d/18kKGWVvHSmFdLRbgWd_wUybZLZWBcNZv/view?usp=sharing
Also did you get my lab file?
https://drive.google.com/file/d/1o6kmIsg9JjtsWaocSBBEWWs99434jES3/view?usp=sharing
The cro...
The WRT300N blocks inbound ICMP traffic only, to be specific the trusted interfaces are the ethernet interfaces associate with LAN. This means the traffic from the wireless access points. Inbound in this context is entering the WRT300N from the inter...
I only changed the connected interface from the switch-PT and WRT300n to a crossover cable. Also, you can't see from screenshot but the WRT300N to the Switch-PT is using it's internet port, so since the WRT300N has four physical ethernet ports I used...
OK I will attach a screen shot for the ACL error if it works, I changed image file to .png. However, to see the issue with the ACL, you put pack tracer in Simulation. Send a ICMP request from Laptop 1 (192.168.100.x) to the 10.60.2.2 WRT300N. You ca...
Also, I noticed your topology has a internet address. The port you are currently plugged into for the WRT300N to the R1/RO router is an internet port. It does make sense that a implicit rule to block ICMP exist on that physical port since it is untru...
