Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do you set the default gateway? using hyperterminalip address outside 192.168.1.25 255.255.255.0the pix sets the default gateway as 192.168.1.25 but the gateway really is 192.168.1.1ThanksMichelle
HiCan anyone tell me why me show route changes after the unit does a power cycle?Starting withpixfirewall(config)# route outside 172.16.1.128 255.255.255.128 172.16.1.129pixfirewall(config)# ip address outside 172.16.1.243 255.255.255.128Cannot remov...
Can I admit to two goals? Increase my understanding of how the pix handles routing of traffic andwould like to send traffic out to the wan, but only to specific networksroute for 192.168.3.192 255.255.255.192route for 192.168.5.0 255.255.255.0but no...
Not sure but I think it does, because if you don't it trys to set the outside default gateway to 192.168.1.25 (which is itself).The network is 192.168.1.0 and the router to the WAN is 192.168.1.1 255.255.255.0the pix is one of many devises in the on ...
Can I use?route outside 192.168.1.0 255.255.255.0 192.168.1.1route outside 192.168.2.128 255.255.255.128 192.168.1.1Would like to route only specific traffic out and have the rest just dye.ThanksMichelle
