Hi, i have open some ports on the router before and without problems, but when im doing it now, the setting is not showing upp in show conf, im typing this command: ip nat inside source static tcp 10.0.0.8 7563 interface cell0 7563
Here is my con...
Hi, im new to cisco but im starting to learning myself.I configure an Cisco 819 LTE Router witch DHCP and it worked good, after some days i configured my cisco switch with wlan tags to my AP.After that i cant assign an ip when i connect my computer, ...
I Found the solution :)show vlan brief!!primar#show vlan briefVLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Gi0/1, Gi0/2, Gi0/3, Gi0/4Gi0/5, Gi0/6, Gi0/9, Gi0/11Gi0/125 VLAN0005 ...
I have removed it and dd it so many times, but i add it again and here it is. One question the ports in the switch also got 192 adresses, isnt port 8 "isolated" enough? !
dot11 syslog
dot11 vlan-name Primar vlan 1
dot11 vlan-name test vlan 5
!
dot11 ...
ssid for vlan 5 is working perfectly, but ssid for vlan 1 is getting 192 ip first, like its some kind of conflict, if i relase and renew ip in the computer it works.And the same problem is with cables connected to the switch im sorry to be an such pa...
What Do you mean that only wan device on port 8 is listening for dhcprequest? Why isnt port 10 doing The same? why is port 8 answering for all DHCP requestsI got some ip cameras on port 3and none of them is asigning any ip more, they should get an 10...
Here are the cfgs, in this case port 8 and 10 in 2960 is the "wan ports" and in 819 Fastethernet0 is to 2960 2960-CXprimar#show confUsing 2269 out of 524288 bytes!! Last configuration change at 00:06:01 UTC Wed Sep 20 2017! NVRAM config last updated ...