About Myghty1

Myghty1 · 01-09-2023

Hello allI am looking to NAT the public IP of a peer end to create a site-to-site VPN tunnel that will replace an existing VPN tunnel.Basically, the current tunnel between Peer A and Peer B1 (200.x.x.1) is up and functioning. Peer A is unable to be c...

Myghty1 · 09-25-2017

~Diagram attached~Is this possible? I am just learning this portion of networking and it is a little bit confusing. Right now, I have a successful site-to-site VPN from the ASA 5505 LAN (192.x.x.x) to the R1 LAN (10.x.x.x) on my 2901 router. Endpo...

Myghty1 · 01-10-2023

Correct, there will only be one S2S VPN. The tunnel connecting Peer B2 to Peer A will replace the existing tunnel between Peer B1 to Peer A. Peer B2 needs to replace B1 seamlessly to build the new tunnel to Peer A. I cannot configure nor access Pee...

Myghty1 · 01-09-2023

Finally had a chance to get back to this scenario and make a rudimentary overview diagram. Below is what I am recreating in my lab environment. So from ASDM on Peer B2 (200.x.x.2) I have the NAT rule below. This rule allows me to ping NATd Peer B...

Myghty1 · 09-28-2017

Thank you much for your reply, Richard. I have scrubbed and attached the config...possibily too much scrubbing.

Member Since	‎09-25-2017 01:15 PM
Date Last Visited	‎01-09-2023 10:29 AM
Posts	5

User Statistics

User Activity

NAT Public IP of 1 peer of VPN site-to-site

Site to Site VPN configured; need remote VPN on same interface

Re: NAT Public IP of 1 peer of VPN site-to-site

Re: NAT Public IP of 1 peer of VPN site-to-site

Re: Site to Site VPN configured; need remote VPN on same interface