After following procedure on:http://www.cisco.com/en/US/docs/security/ips/6.0/installation/guide/hwImage.html#wp1183593Module becomes UNRESPONSIVE, after hw-module module 1 recover boot command.I'm using IPS-SSM_20-K9-sys-1.1-a-6.1-1-E1.img¿Any idea...
According to SurfControl is it possible to use a L4 - L7 load balancer to bear the 10000 per server limitation.Is the any know option to do this using the ACE module?
Hi,We are about to install a couple of FWSMs, and I'm looking for additional documentation about this Module; looking at the Documentation, I was not able to find any working configuration, is there any place where I can have a copy of this.ThxGus
ciscoasa(config)# hw-module module 1 recover boot The module in slot 1 will be recovered. This mayerase all configuration and all data on that device andattempt to download a new image for it.Recover module in slot 1? [confirm]Recover issued for mod...
Hi,After making the procedure module is now on RECOVER mode, it never goes to UP.--- -------------------------------------------- ------------------ ----------- 1 ASA 5500 Series Security Services Module-20 ASA-SSM-20 JAF11120177Mod MAC Add...
Thx for the reply Gilles.Is it possible to select only www, https, dns traffic to be sent to the farm and leave the rest to follow the way out to the next upstream devive?Gus
DmitryAFAIK there is not way to accomplish what you are trying to do here. You can also check the RFC that talks about ARP. I think that using static arp entries for this router and disabling proxy-arp might be a workaround for this. Another thinking...
Hi RenuWhen you have ATM intefaces some ISP's force you to use bridging; you are correct while thinking about using IRB, since it can bridge but also can brige.Now here is the trick, you need to split this router in to two, so the portion that goes t...