Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
By default, all traffic from the client goes through the tunnel, this is normal behavior. In order for users to have access to the Internet while connected via vpn, you will need to enable split-tulleling on the device that the vpn clients are conne...
You do not need a match address for a client, only with a lan to lan.... However..... you are using access-list 101 as a split-tunnel list. ONLY traffic in access-list 101 of your config will be considered "interesting" and go through the vpn tunnel...
The priority is used so that you can define multiple ISAKMP policies...... The PIX will compare the ISAKMP SA it receives to it's defined policies, begining with the lowest numbered policy, then if that does not match, it will check the next higher n...
Cisco IOS does not currently support the Unity VPN Client 3.0. This is planned for release 12.2(7)T which is not out yet. You will need to use the Cisco Secure VPN Client 1.1 until the IOS release is out that supports the 3.0 client.
