Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
To answer both questions:1) So how does the CP know that this Map Request should be resolved using the Address Resolution table (show lisp instance-id L2IIDXXXX ethernet server address-resolution) rather than using the typical behavior?Three methods ...
If upgrade is not a possibility, you can do it manually too in AireOS The CLI way to create the ACL on the AireOS is a bit more complex (and tedious in some way) than doing it on the GUI; so I would create another one via GUI and add it to the FLEX...
Starting 2.3.5.x you can customize the pre-auth ACL :
https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2-3-5/user_guide/b_cisco_dna_center_ug_2_3_5/m_configure-network-settings.html
Effective...
Another use for this command (again in SDA 1.0) is SDA Transit.A remote border will register a remote fabric prefix to the Transit Control Plane, and then the TCP will take the registration, export it as LISP route, redistribute it into BGP and adver...
Exactly as you say:Borders needs the BGP VPNv4 local sites to:1) Announce them to upstream Fusion/WAN2) Convert these entries to map-caches, so it can trigger resolution for North-South traffic.Example.Traffic from outside the fabric hits Border A to...
