Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have tried to upgrade a customers network of ASR9001 routers running XR 5.3.1 to 6.3.3, and also 6.4.2, but both of them fails when attempting the "install add"-operation. Image download and files has been equisitely verified with md5, and the fil...
While this is definitely not a design I would recommend, since it merges the DC network module and the Client Access network module into a single layer and fault domain in the overall arthitecture, it is absolutely possible if you look at it purely f...
@SunilKhanna wrote: The command is neighbor ip-address as-override and can only be executed under the VPNv4 address-family.This sentence must be a typo. The as-override feature works only for IPv4 and IPv6 address-families (for VRF, and global routin...
This was very helpful. Hopefully the bridge-SMUs which Xander talks about will also be made publicly available via Software Downloads (I can't find any at the moment, so I guess going through TAC is the only way to obtain them p.t.)
Thanks for shar...
Where did you find this document?? I have been searching all over Cisco.com and went through all available Upgrade and Software Management guides for ASR9000 / IOS-XR. Also, Release Notes for 6.3.3 does not mention any prerequisite version for a norm...
We have already done this, and the md5 is verified after the files have been transferred to the router. But when on version 5.3.1 the router still complains that the PIE-files are corrupt (we have tried many of them, not just one or two). However, up...
