Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The problem with the "pick up and dial" when behind a call-manager is that the device needs some way to know if it is going to need to dial out or dial to a local extension. If we were to force all calls to grab an outside line, you couldn't dial bet...
You should be able to do a "show run int in0/0" from the CLI and get the information about the module. My output is below, we can see the "service-module ip address 10.1.10.1" gives us the address of the CUE.UC_560#show run int in0/0Building configur...
How is the port on the SF-300 configured that is attached to the phone? What about the port that is connected to the UC?One thing you may want to try is just making the phone port an access-port in vlan 100 (assuming you are using this as your voice ...
Without too much information it is hard to say, but a few things come to mind.First is asymetric routing. The ASA doesn't being left out of the loop so to speak when it comes to stateful traffic. What might be happening is this:Forward path: Data vla...
