Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, We have purchased new Cat 4500 X series switches, we are getting below error NO SUPPORTED POWER SUPPLIES DETECTED ON LOCAL SUPERVISOR SUPERVISOR WILL BE POWERED DOWN!!!!Pls fidn the BOM attached, As per the data sheet Power supply seems ...
Dear All,We are integrating Cisco Prime with 3rd Party ticketing tool, However, We are getting SNMP traps for device unreachable which is getting new ticket created in ticket tool, Meanwhile, we are also getting alarms for reachable & ticket is also...
Dear All,We have approximately 300 devices in WAN (All connected with MPLS links), How can we discover the devices using APICEM, Autodiscovery ThanksPhani
We are unable to access the HTTPS link on APIC-EM, Services were running last week & we had unexpected power shutdown, once after the power restoration, we are unable to access the application via HTTPS. I checked with grape instance status command ...
Hi Kelli Glass,Both links give the minimum requirement & steps we can take, However as of now we are unable to get console access to enter commands itself. I think it might be some HW issue or compatibility issue. If you have some TS steps on the er...
Misha,Thanks for the suggestions, there is no devices which as seeds of CDP, I understand we need to discover site wise , Is there any option to upload the device list rather adding manually, Could suggest for API if any ? ThanksPhani
are you referring to the discovery process in APIC-EM or is it a different app ?I tried using the same however zero devices detected, Meanwhile I am reconfirming the policy in FW for discovery purposed port opened or not.
Yes, App responding.During the rest_grapevine i got an error of NTP is not syncing, After configuring the NTP using Config_Wizard command, now the application is up & running, no data loss.ThanksPhani
