Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,1- I need to create ssh user who can only see/read the config details of router/switch.2- Also i do not want to share enable password with read-only user, is there any way to create separate enable password for that user too.Thanks & Regards:
I have configured OSPF and GRE Tunnel 50 in HO & branch routers. All routers were working fine but suddenly from last month, one branch router starts giving below error and i lost connectivity. %OSPF-5-ADJCHG: Process 3, Nbr 172.16.50.2 on Tunnel50 f...
Hello,I have configured ssh on 2 cisco routers in one branch. Both of them was working fine but one day suddenly one of the router's ssh stopped working. Now when i try to access by putty, immediately it gives me error message "Server unexpectedly cl...
Hello Everyone,I am facing slow speed issue over mpls link.We have 8mbps Mpls line at our Head Office and remote branches have 4mbps link. Head Office and branches are connected to each other by DMVPN. I am trying to copy some files of almost 300mb s...
Hi,we are using MPLS link without internet for the connectivity of our branches. For internet we have separate line from ISP. But now one of our branch internet is not working, i want to share my HQ internet with that branch through MPLS link, Please...
Hello Dear,I created enable password for level 5 and level 3 and level 0, also i created different usenames for each level, but enable passwords are not working for level 5,3 or 0
Still i am not getting output as expected, Once i login with read only user, it asks for enable password, and it does not accept the enable password which i created for level 3, it accept only admin enable password, after entering into enable mode, i...
I am not able to access with new level 3 enable password, and if i access by MY anable password, new-user is able to enter into the config mode, below is the config details. 02-GW#sh runnBuilding configuration...Current configuration : 8444 bytes!! L...
Hello Dear, I did that already, After login by new Read-only User, it asks for enable password(which i do not want to share with this new user too), but once i enter enable password, i am able to go into config mode and etc
Dear All, Thanks for your replies, I have changed the router port 2 days ago, and it is working fine since then,, seemed there was some hard ware issue.
