Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I want to announce an iBGP learned route to eBGP peers..this is my outputR8#sh ip bgp neighbors 203.172.5.1 advertised-routes ; this is my eBGP neighborBGP table version is 14, local router ID is 180.20.61.1Status codes: s suppressed, ...
the problem was in the prefix list!I'm not enough trained in bgp... thanks a lot! it is working now.I've permited my previously non-advertised, iBGP learned route, in each prefix list for each eBGP neighbor, and after that i've "clear ip bgp * out".....
Peter,The config i've posted is from Router C, here is what you askedCore_Borde#show run | section router bgprouter bgp 54444no synchronizationbgp log-neighbor-changesnetwork 200.141.224.0 mask 255.255.248.0network 200.141.224.0 mask 255.255.255.0net...
didn't work the clear ip bgp :sthe output: Router_C#clear ip bgp * outRouter_C#sh ip bgp 179.35.3.0BGP routing table entry for 179.35.3.0/24, version 14Paths: (1 available, best #1, table Default-IP-Routing-Table) Not advertised to any peer 23456 ...
Milan, in the last post, I've outlined the topology of my situation, does it help?Answering your questions:1) no filters are implemented,2) is not a next hop reachable from R8
Yes, it is like this:(200.124.120.0, ASN X, 4 bytes format)-->Router_A<---eBGP--->Router_B<-----iBGP--->Router_C<---eBGP--->Router_DRouter A and Router B are eBGP peers, differents ASs.Router B and Router C are iBGP peers, same ASRouter C and D are e...
