Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi experts,I would like to double-check an ISE proposal I'm sending to a customer.In my customer's scenario there are 2 DCs (located in the same medium size country) which are connected via layer 3, and are redundant of each other. In each DC, we'll ...
Hi,I have that is deployment Cisco 1100 routers for an IPSec deployment. The C1100 have a 8P LAN switching with 802.1X and RADIUS support.Therefore the customer will require both a Radius Server to authenticate the end devices that connect to the LAN...
Hi experts,In the ISE 2.3 Compatibility Matrix I can see that profiling is supported for SG500 is a limited fashion:Cisco Identity Services Engine Network Component Compatibility, Release 2.3 - CiscoCan we get more information on the scope of profili...
Hi experts,I have a customer that wants to understand if we can authentication a user using both 802.1X AND Mac address authentication at the same time, i.e., not only make sure the user/pass is correct but that the MAC address of his device should b...
"Not sure why 2 psns needed at each site however? Seems like overkill if the psn supports 40k endpoints and you have only 22k then each site by themselves would run fine for the whole network"Just one PSN in DC#2. DC#2 will only be used in a disaster...
Hi Krish,Thank you for your quick reply and for the latency/bandwidth documentation. We won't have latency issues in this case and I see that BW won't be very significant. I'm more worried from a networking perspective - the fact that the DCs are L3 ...
No particular use-case in mind yet - the customer is evaluating ISE and he is trying to understand the limitation for the existing SMB switches he has.So as I understood from your answer, the only probe we would use is RADIUS for the SMB switches. We...
