Hi Manfred Thanks for the feedback. Yes we are going to allocate line card 5 and 6 actually  to another vdc later on so updated step 9 to only allocate line card 3 and 4 back to the prd-cs-a vdc and we will add just move the config from line card 5 t...

Hi Manfred  Thanks for sharing your process for the M1 to M3 cards that is much appreciated. based upon what you were doing I have created my  process to migrate from M2 and f2 to F3 does this seem logical from your experience ?.   As M2 F2 and F3 ca...

Thanks for that so config will be lost once new card goes in and restore from back up then.  I ad this plan below for trying to preserve the config but by sounds of it its a mute point anyway Also should we suspend the vdc at some point in the proces...

Hi Did you end up getting and answer to this question as well as going thru and replacing the m1 with m3 cards and what was the outcome ? I am looking at similar process but going from M2 and F2 to F3 cards on same vdc ? Thanks