Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello, anybody can brief about fixup command for eg "fixup protocol smtp"what exactly it doess on smtp protocol when we configure above mentioned commandthanx®ardsrajesh
Hi every out there,i'll be installing pix firewall with exhange server behind it.for incoming and outbound mails what are the ports or conduits i have to open . if anybody send a script that 'll be good for me to troubleshoot.thanx in advancewarm reg...
i have two sites connected thro isdn link. without ppp multilink ISDN IDLE TIME-OUT is working fine .when i enable ppp multilink with dilaler load threshold second channel always up even when there is no traffic.dialer idle time-out is 60 sec diale...
i have cisco 770 isdn router .it supports only set based commands.i am using it for internet access . the router is up running . but now i wanted to change existing USER NAME and PASSWORD with new USERNAME and PASSWORD supplied by ISP. how to se...
hai,u should have configured static nat for web server in dmz with registered ip . and by default ping an dt raceroute are disabled on outside interface .thanx®ardsrajesh
Hi gpauwen, Thanx for the immediate response. my concern is if i make new profile with new USERNAME , I have to configure routing and dialing parameters with that profile or existing parameters bind with that new profile .thanx rajesh
