Hello,I have to make an IPSec tunnel between a Cisco router and a NetScreen firewall.I have to use aggressive mode because the router has a dynamic IP address.But when I try to establish the tunnel, I get this error:ISAKMP (0:1): Can not start Aggres...

Hello,How can I use the PPP peer IP address as default route like with "add default HISADDR" in BSD ppp daemon ?Regards

HiI have two edge routers and two core routers:+--------+ +--------+| edge A | | edge B |+--------+ +--------+ | |+--------+ +--------+| core A |-------------...

Hello,NAT isn't working on a router after an IP addressing change. When I try to use NAT with nat debugging enabled, I get the following message in the logs:NAT: translation failed (A), dropping packet s=local_ip d=remote_ipOn Cisco website, I found ...