Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A have setup c1721 with 2xWIC-2A/S as Access Router with one line enabled for incoming calls and outgoing calls to ISP. Access works fine, but dial-out does not.Here is a part of router setings and some debuging infos folows!interface Serial3 physica...
Hi,I have a terible problem. I use 3Com PRO TA connected on c1721 + WIC-2A/S as dial-in server and 3Com PRO TA as dial-in modem, too.I get the folowing log:1d02h: TTY1: DSR came up1d02h: tty1: Modem: IDLE->(unknown)1d02h: TTY1: EXEC creation1d02h: TT...
Hi,My question is:Is it possible to have diferent CBCA rules on the same asynchronous interface (modem), one for access calls and one for dial-in calls, controling them using Dialer profiles. One for access and one for DDR.If it's possible, PLS, some...
I need to connect > 20 remote offices using 64K leased lines to the Central office. I don't want to use separate port for each connection. I want to bundle them to one E1 line.Is it possible, what technology: interfaces and protocols should I use at ...
~Zulfi, thanks for answeringIt is WIC-2A/S connected to 3Com ISDN PRO-TA.I have add the settings for the other Dialer Profile taht use the same modem for receiving the calls. It's works fine. I use two Dialer Profiles becouse I have diferent ip acces...
Thanks Laurent,I thought it might be posible with chanalised E1, but all I have found till now was multichanel E1 used in 7xxx.Could you give me any link to a doc that use this solution. PLSRegards
It would be very nice and simple but my TELCO offers FR in much higher price than leased lines or IP-VPN. IP-VPN is a recomanded solution but I would prefer to have a complet control.I have influence in my TELCO and they would provide me this nx64K b...
