Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I believe it is normal for the backup WDS's to show NOT AUTHENTICATED. When it becomes the active WDS, it should change to SECURITY KEYS SETUP. You can test this by lowering the priority on the primary WDS to less than 216.For the "AP registered wit...
If the clients are only supposed to connect through the VPN server, use an access-list on the APs wireless interface that only allows clients to communicate with the VPN concentrator. Don't forget to allow dhcp through the access-list also.Another op...
The question was not about the differences between ad-hoc (Independent BSS) and Infrastructure BSS. I would suggest using the infrastructure-client setting for the radio interface to allow reliable broadcast/multicast to the workgroup bridge. Adding ...
Depending on the boot block version, console into the AP press ctrl-w or esc when booting it up. Then follow the instructions below about copying the keys and formatting.http://www.cisco.com/en/US/products/hw/wireless/ps430/products_password_recovery...
