Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
normal the device uses for nat and pat function,cpu load is about 20 % with 40M traffic,sometime ago, i discovered the internet speed suddenly down,then i used ping and trace tools.discovered the pix make a large delay.cpu usage was 98 percent.i have...
if use rip ,eigrp , ospf in an environment,how to decision the route and set up the route table.prefer the prefix > disntance > cost or prefer distance > cost (don't uses prefix setting up the route table )
this is a second time to happen.i have been change logging buffered level to errors.it appear in the blue .the default route have been set a next-hop ip address.then i should be waitting the thing to occur.thanks.
