Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,I would like to convert a Z3 port 4 to be an internet port for my secondary Link.Is this feature available on Z3 or it is only available on Z3C ?
Hello Community,I am designing Meraki solution for several countries which will be under one organization. Each of this countries will have Several MXs and Zs which will form autovpn with Hubs in routed mode located in each country. Am anticipating s...
Since hubs within the same organization peer to each other automatically, will this cause a problem with crushing spoke IP subnets in different networks? Lets say spoke 1 peering with Hub 1 doesn't need to communicate with spoke 2 peering with Hub ...
Hello Guys,I have two questions. 1. The routes status am learning from the hub via autovpn keep spinning up instead of being green. which is the correct status ?2. On my Hub route table am seeing routes for the other Hubs although am not doing any s...
@DarrenOC @Christian_Ney When I login on the local page. The port section does show up for me to change role. Any extra thing I need to do?. below is the local page.
@jdb1 1) meraki does not allow to have same subnets "in vpn" on spokes at 1 organization. This means that when I try to enable vpn mode at the spoke it will automatically refuse sees the spoke is learning the same subnet from the hub ?How ...