Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am configuring a guest access solution with multiple guest access gateways associated with a single VLAN. Each gateway will have its own /24 network, and obviously it own gateway. The interface configuration page requires a single gateway in the IP...
When IOS TKIP countermeasures are enforced is any message generated in the AP log? Firmware rev is 12.3(8)JEB.Typical command to configure this would be:interface dot11Radio 0countermeasure tkip hold-time 60Also, does any know of a tool to generate 2...
Thanks for your replies. 2 Coova gateways each with web authentication and a dhcp server plugged into each layer2 vlan works great with IOS APs, which do no require IP config per (vlan) subinterface.The objective is to loadbalance, provide redundancy...
We are testing an air-wlc2006-k9 and 3 air-ap1010-ak9's. 1010's APs are LWAPP only.I have noticed that the controller sometimes does not see one or more of the APs. Power cycling the APs sometimes brings them back. We have a non-Cisco infrastructure ...
We tested PEAP and TTLS. PEAP seems desirable though apparently Microsoft and Cisco implementations differ, but we got TTLS to work first.We are using 1200's, 12.2(13)JA4, Macintosh and PC clients with TTLS. It is supported in Mac OS 10.3 and above. ...
We are using Mac OS 10.3, IOS 12.2.13JA3 and JA4; TTLS and PAP. We upgraded 2 APs to IOS 12.3 and they are functional with no problems so far. We haven't tried LEAP, as our primary platform is Mac. Hope this helps...
I haven't contacted TAC yet since I can't translate Airmagnet's Association table overload into Cisco speak. Right now all I could do is send Cisco an Airmagnet packet file.I didn't reboot when the problem occurred because I had mulitiple client usin...
