I have a 5 device license of CiscoWorks 2.2 and a Windows 2003 Server. This version of CiscoWorks won't install on Server 2003. Has anyone come up with a way around this or is it just not possible?
I configured dot1x on a 3550 port which is connected to a Windows XP client. I am using radius and I can do debug authentication and I see the switch asking the client to authenticate, however the client machine never prompts for authentication. The ...
I configured a WebVPN on my 3005 concentrator and configured application support. My understanding is that when I configure the ports for the application the local machine's HOSTS file is supposed to be automatically edited to allow the application p...
Hello,I have run into a scenario where the objective was to only allow a router to connect to a 3550 port if the router had a specific IP address assigned. I know how to do port security with a mac address but how can this be done with IP address? If...
Hello,I am confused on aaa accounting. If I wish to account all commands and the levels I have configured are say 5 and 15, do I need to include level 0 in my aaa accounting commands?
Thank you for the response. However, I believe the same that exists with ACL will exit with route policy. You still have to match some source/destination address. So if you lock down to the IP address of the router on that port you block out any tra...
I am not trying to filter IP based on MAC. I am trying to filter IP based on IP. Take away MAC filtering. How can I allow only a specific IP on a switchport without affecting transit traffic that may generate from behind the device on that switchport...