Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is scenario:Router has couple of outside interfaces and also there are 3 static default routes to outsides with different metrics:1) Fa0 (metric 30)2) Tunnel0, GRE over Fa0 (metric 20)3) Tunnel1, GRE over Fa0 (metric 10)The main idea to use lin...
I have log message PIX-6-110001 for global addresses which I am using for outgoing connections from inside interface to outside.pix506e# sh globalglobal (outside) 101 213.xxx.xxx.101global (outside) 102 213.xxx.xxx.102pix506e#May 6 23:18:29 PIX %PIX...
Hello.I wonder if it possible to assign IP address to VPDN client from RADIUS or TACACS server like as in IOS? After some attempts as I understand now it is not possible, please correct me if I am mistaken and put on the correct way. ThanksSergey
If I understood this in the right manner it is easier to do this in your case. I guess that 3 diff. companies has separate address space and it can be done with Route Maps, here is link: http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products...
It is clear about 'ip nat outside', I did in this way before post you see:rtr#sh ip nat statisticsTotal active translations: 0 (0 static, 0 dynamic; 0 extended)Outside interfaces: FastEthernet0, Tunnel0, Tunnel1Inside interfaces: FastEthernet1But w...
It seems all works fine as it was and internal users have no any problems just I am worried about log message and possible wrong config.Please have a look at sh run in attach.so here simple --ROUTER--PIX--LAN--:213.xxx.xxx.97 - router before PIX on o...
