Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have to renew the admin certificate in a pair of ISE nodes (Prim / Sec) on Version 3.2.0.542 Patch 4.
Currently both devices have the same admin cert that expires in little over 3 weeks.
All the names and IPs in this thread are placeholders.
I gene...
The change when perfectly. As it should, the ISE service was rebooted, not the server as a whole.The services were rebooted one at a time, so at all times there was at least one active node.
Thanks for your reply.
The thing is that both devices have the same cert for administration, so when I bind the CSR for admin, the Primary and Secondary nodes should be affected, right?
If I understood correctly(Cisco Documentation), it says that the...
Thank you both for your responses.
The certs for "Eap Auth" are separate ones. The guest portal is not currently in use.
I'll schedule a maintenance window just in case, but your answers have cleared the worries I had.
Thanks Aref for your response.The backup I imagine should be recovered through the CLI. And even though the certificates are not exported in the backups, as they should still be loaded on the device they'll be used.
Is there, that you know, a proced...
Hello all. I have this issue myself (as during the nights there are low to no authentications) and wanted to change the window to 30/60 minutes. When I try it it says that the Threshold is invalid as it is negative.
I imagine that if I put a valid v...