Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Pix 515e, while users establish vpn they cannot browse the internet. Is there a way to enable internet browsing through the pix without split tunnel?
I connect with vpn client v 4.0.3f to the pix 501 v6.2, however I can access resources on the remote lan only after I initiate some kind of connection from the remote lan to the vpn client (a ping for example).Could the fact that I don't get any dhcp...
We have pix 501 6.2 connected to adsl router and one public ip,when trying to connect using vpn client 4.0.3(f) the connection is established but user cannot access remote network-no pc's are availble and no ping.Attached are two files with the pix c...
We have Pix 6.2 ,I am able to establish a vpn connection using vpn client 4.0.3f but I don't seem to connect to the remote network.Looking at the vpn (ipsec) connection log on the pix I get this line which looks like a problem :local ident (addr/mas...
We have pix 501 6.2, I succeed in establishing a vpn connection (remote client with cisco client) but I can't access any pc on the remote network nor can I ping them.The pix is behind a router which configured to pass ipsec and l2tp.When I connected ...
Thanks for the reply.I cleared the two crypto map lines as you suggested but when I wrote the isakmp nat-traversal command the pix didn't recognize it (perhaps because the version is 6.2).Is there something else I can do?Thanks, Dagesh
HiThanks for the reply, it seems like the configuration matches the one in the link (though, it is possible I've missed something), however, I've noticed that I get no gateway address in the vpn connection and couldn't find a way to solve it.Any sugg...
Thanks for the reply.I am now able to connect through the vpn (with vpn client) but I can't see any computer on the remote lan (the one I try to connect to), I get the right IP but the subnet mask is wrong - class A instead of class C with IP 10.0.0....
