Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi !1. Check the routing (as already stated :-))2. check conduit permit ipsec.. if it's not there turn it on or add rules to allow traffic over the vpn tunnel3. Check that the client can send and receive port udp 500 and 4500 on the cp firewall4. che...
Hi !Have experienced the same types of problems. All of them resolved when lowering the MTU to 1390 (even though packets were not fragmentet at 1420)Try messing about with the mtu Jorgen, Ementor
also note that the 4.x client do not install the outside interface of the pix in the crypto routing table of the client (it does so automaticly in 3.x).After upgrading to version 4 we no longer could manage the pix over the vpn tunnell (we used manag...
Hi !I have never tried relaying through a VPN tunnel before, but should'nt relaying always use the IP address of the interface wich received the DHCP request ? how else would the dhcp server know to wich network it should lend an IP address ? Anyway...
Hi !This will not work since the server you are trying to reach are on the outside of the pix. (it's in the passage way of the vpn tunnel). You'll need to put the share in the 192.168.1.0 network.You also say that 192.168.0.2 is your share.. is this ...