Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Yuan;I didn't use RME 3.5 before but I usually backup my important configuration and imaged from devices using CLI Interface .for Example in a Catalyst Switch :Switch#copy flash:config.text tftp:this command copy file named "config.text" from sy...
Dear aliver;An Ethernet link need two things for working properly in Cisco Devices .First "Interface" State and Second "Line Protocol" State .any time both of them have "UP" value the link is stable . and if one of them goes down Link is Down .For Ex...
Dear Cliff;I'm not sure that it really works ! But solved my same problem .my consol response time in a Catalyst 2950G24 when cpu is 80% load and above , comes to more slow and slowly .I changed my consol baud rate from 9600 bps to 57600 bps and it's...
for more reliable link and secure link state its recommended to statically set your port transfer mode to FULL/HALF and 10/100/1000 Mbps link speed .attention to these notes :-- A Port set to Full Duplex connected to another that set to half duplex s...
Dear Dave;It seems that almost 1/4 of your incoming packets are Broadcast !!in this case (L3 Switching) you must have a high CPU load and delayed packet forwarding .if that's right you have a Broadcast Storm that may cause you network to Force Down !...
